Control cable C8 (Yamaha/Suzuki/Tohatsu/Honda/Selva/Force/Volvo/Yanmar/Volkswagen) 33 ft (10.06 m) Imnasa

Detailed description

Mechanical control cable for transmitting throttle or gearshift movement between the control lever and the engine in compatible installations.

Applications listed in the catalogue: Yamaha, Suzuki, Tohatsu, Honda, Selva, Force; Volvo, Yanmar, Volkswagen. Check the series, end fittings, stroke and length of the installed cable. The engine brand alone does not establish compatibility: the control unit and connections must also match.

• Series: IMNASA C8
• IMNASA reference: 13195033
• Length: 33 ft (10.06 m)
• Stroke: 88 mm
• Sheath diameter: 8 mm

Measure the complete route from the control to the engine, allowing for the required bends. Install without tight bends or chafing and check full throttle or shift travel before using the boat.

Sold individually. Throttle and shift may require separate cables. Representative series photograph shared across the available lengths.

How to choose and measure the cable

Ordering length is shown in feet and metres. 1 foot = 0.3048 m: 9 ft = 2.7432 m (approximately 2.74 m). Displayed metres are rounded to two decimals; the reference identifies the commercial length in feet.

For Imnasa references, feet identify the nominal ordering length in the catalogue. The consulted documentation does not provide a separate sheath length or a measurement datum for each terminal. First check the series and length printed on the existing cable. If you only know the sheath length, confirm the reference before ordering; do not apply a fixed terminal allowance.

For a new installation, measure the actual route from the control to the throttle or shift connection, including bends. For outboards, the catalogue diagram adds 3 ft (approximately 0.91 m) to allow engine movement. For inboards and sterndrives, use route A+B. Choose the next available commercial length that covers the route and avoid excessive slack and tight bends.

Sheath length, diameter and stroke

Outer sheath length, sheath diameter and working stroke are different measurements. A sheath diameter of 8.6 mm describes its outside thickness; an 80 mm stroke describes the useful terminal movement. Neither is the cable length. Separate sheath lengths are not published for these references and cannot be calculated by subtracting the stroke.

Before ordering, compare both end fittings, threads or attachments, cable series, control, engine, year and required stroke. Adaptors may be needed. Matching engine brand and length alone does not establish compatibility.