Control cables for Evinrude

Control cables for Evinrude

Choose the series, then the length in feet and metres. Check the engine model and year, control generation, end fittings and travel: the engine brand alone does not guarantee compatibility. The same product listings can be found by engine, cable manufacturer or model.

Nominal ordering length; this is not a separate measurement of the outer casing. Check the marking on the previous cable and do not calculate the outer casing length by subtracting the travel.

For a new installation, measure the actual routing between the control and engine and consult the guide for the selected series. The allowance for outboard turning depends on the manufacturer: Dometic / Teleflex specifies 4 feet (1,22 m); Multiflex specifies 3 feet (0,91 m). Round up to the next commercially available length. When replacing a correctly installed cable, use its overall length or marking without adding this allowance again. The ordering length is not the separate outer casing measurement.