Control cable F08/C8 (Yamaha/Suzuki/Tohatsu/Honda/Selva/Force/Volvo/Yanmar/Volkswagen) 7 feet (2,13 m) Riviera

C8-07' [Control cables F08/C8 · Riviera]
Control cable F08/C8 (Yamaha/Suzuki/Tohatsu/Honda/Selva/Force/Volvo/Yanmar/Volkswagen) 7 feet (2,13 m) Riviera

Control cable F08/C8 (Yamaha/Suzuki/Tohatsu/Honda/Selva/Force/Volvo/Yanmar/Volkswagen) 7 feet (2,13 m) Riviera. Before choosing, compare both end fittings, thread or fastening type, cable series, control, engine, year and required travel..

Read more
RRP38,03€VAT included
Offer price30,17€VAT included
Special offer
Available. Receive it between and Order by Wednesday 18 at 15:00 (Spain time).
Time remaining: 04:18:08
0/10 (0 votes)
Your opinion matters to us!
Thank you for your cooperation!
Votar:

Detailed description

Mechanical control cable for transmitting throttle or gear shift movement between the control lever and the engine in compatible installations.

Applications listed in the catalogue: Yamaha, Suzuki, Tohatsu, Honda, Selva, Force; Volvo, Yanmar, Volkswagen. Check the series, end fittings, travel and length of the installed cable. The engine brand alone does not confirm compatibility: the control and its connections must also match.

  • Series: Riviera F08 / C8
  • IMNASA reference: C8-07'
  • Length: 7 feet (2,13 m)

Measure the full route between the control and the engine, including the necessary bends. Install the cable without sharp bends or chafing and check the full throttle or gear shift movement before using the boat.

Sold individually. The throttle and gear shift may require separate cables. Representative image of the series, shared across its different lengths.

How to choose and measure the cable

The ordering length is given in feet and its equivalent in metres. 1 foot = 0,3048 m: 9 feet = 2,7432 m (approx. 2,74 m). The metres shown are rounded to two decimal places; the nominal size identifying the reference is the length in feet.

When replacing a Riviera or Ultraflex cable, the manufacturer specifies measuring the entire cable from tip to tip, including its ends, and checking the length marked on the sheath. Do not measure only the outer sheath section. If the previous installation was correct, do not add the allowance for engine turning again to the old cable's measurement.

For a new installation, measure along the entire actual route from the control to the throttle or gear shift connection, including bends. For outboards, the catalogue diagram adds 3 feet (approx. 0,91 m) to allow engine movement. For inboards and sterndrives, the route A+B is used. Choose the next available standard length that covers the required route and avoid excess cable and sharp bends.

Sheath length, diameter and travel

The outer sheath length, its diameter and the working travel are different measurements. For example, a sheath diameter of 8,6 mm indicates its outside thickness; a travel of 80 mm indicates the usable movement of the end fitting. Neither value is the cable length. The separate sheath length is not published for these references and is not calculated by subtracting the travel.

Before choosing, compare both end fittings, thread or fastening type, cable series, control, engine, year and required travel. Adapters may be necessary. Matching the engine brand and length alone does not guarantee a fit.