Control cable F14/C14 (Johnson/Evinrude/OMC) 18 feet (5,49 m) Riviera

C14-18' [Control cables F14/C14 · Riviera]
Control cable F14/C14 (Johnson/Evinrude/OMC) 18 feet (5,49 m) Riviera

Control cable F14/C14 (Johnson/Evinrude/OMC) 18 feet (5,49 m) Riviera. Before choosing, compare both end fittings, thread or attachment type, cable series, control, engine, year and required travel. Adapters may be required. The.

Read more
RRP55,65€VAT included
Offer price44,15€VAT included
Special offer
Available. Receive it between and Order by Thursday 19 at 15:00 (Spain time).
Time remaining: 17:45:19
9/10 (9 votes)
Your opinion matters to us!
Thank you for your cooperation!
Votar:

Detailed description

Mechanical control cable for transmitting throttle or shift movement between the control lever and the engine in compatible installations.

Applications listed in the catalogue: Johnson, Evinrude and OMC, from 1979 onwards, with C14 / F14 connections. Check the series, end fittings, travel and length of the installed cable. The engine brand alone does not confirm compatibility: the control and its connections must also match.

  • Series: Riviera F14 / C14
  • IMNASA reference: C14-18'
  • Length: 18 feet (5,49 m)
  • Travel: 75 mm
  • Outer casing diameter: 7 mm

Measure the full route between the control and the engine, including any necessary bends. Install the cable without sharp bends or chafing and check the full throttle or shift movement before using the boat.

Sold individually. The throttle and shift may require separate cables. Representative photograph of the series, shared across its different lengths.

How to choose and measure the cable

The order length is given in feet with its equivalent in metres. 1 foot = 0,3048 m: 9 feet = 2,7432 m (approx. 2,74 m). The metre values shown are rounded to two decimal places; the nominal size identifying the reference is the length in feet.

To replace a Riviera or Ultraflex cable, the manufacturer specifies measuring the entire cable from end to end, including its end fittings, and checking the length marked on the outer casing. Do not measure only the outer casing section. If the previous installation was correct, do not add the allowance for engine turning again to the old cable measurement.

For a new installation, measure along the entire actual route from the control to the throttle or shift connection, including bends. For outboards, the catalogue diagram adds 3 feet (approx. 0,91 m) to allow engine movement. For inboards and sterndrives, the A+B route is used. Choose the next available standard length that covers the required route and avoid excess cable and sharp bends.

Outer casing length, diameter and travel

The outer casing length, its diameter and the working travel are different measurements. For example, an outer casing diameter of 8,6 mm indicates its external thickness; a travel of 80 mm indicates the usable displacement of the end fitting. Neither of these values is the cable length. The separate outer casing length is not published for these references and is not calculated by subtracting the travel.

Before choosing, compare both end fittings, thread or attachment type, cable series, control, engine, year and required travel. Adapters may be required. Matching engine brand and length alone does not guarantee a fit.

Customers who bought this product also purchased

Ventilation grille Nuova Rade · 82 × 82 mm · round · white · 12409
2,64€2,09€
Fastest delivery
IMNASA engine paint for Evinrude, new blue
14,34€14,34€
Fastest delivery